List of ASTM Standard 9501 to 9600

ASTM    D 4289-13 : Standard Test Method for Elastomer Compatibility of Lubricating Greases and Fluids
ASTM    D 4290-07(2012) : Standard Test Method for Determining the Leakage Tendencies of Automotive Wheel Bearing Grease Under Accelerated Conditions
ASTM    D 4291-04(2013) : Standard Test Method for Trace Ethylene Glycol in Used Engine Oil
ASTM    D 4292-10 : Standard Test Method for Determination of Vibrated Bulk Density of Calcined Petroleum Coke
ASTM    D 4293-83(2008) : Standard Specification for Phosphate Ester Based Fluids for Turbine Lubrication
ASTM    D 4294-10 : Standard Test Method for Sulfur in Petroleum and Petroleum Products by Energy Dispersive X-ray Fluorescence  Spectrometry
ASTM    D 4295-89(2012) : Standard Classification for  Rubber Compounding Materials—Zinc Oxide
ASTM    D 4296-83(2009) : Standard Practice for Sampling Pitch
ASTM    D 4297-10 : Standard Practice for Sampling and Handling Bisphenol A (4,4′ -Isopropylidinediphenol)
ASTM    D 4298-04(2010) : Standard Guide for Intercomparing Permeation Tubes to Establish Traceability
ASTM    D 4300-01(2013) : Standard Test Methods for Ability of Adhesive Films to Support or Resist the Growth of Fungi
ASTM    D 4301-05(2013) : Standard Test Method for Total Chlorine in Epoxy Resins and Compounds
ASTM    D 4302-05(2010) : Standard Specification for Artists’ Oil, Resin-Oil, and Alkyd Paints
ASTM    D 4303-10 : Standard Test Methods for Lightfastness of Colorants Used in Artists’ Materials
ASTM    D 4304-13 : Standard Specification for Mineral and Synthetic Lubricating Oil Used in Steam or Gas Turbines
ASTM    D 4306-13 : Standard Practice for Aviation Fuel Sample Containers for Tests Affected by Trace Contamination
ASTM    D 4307-99(2010) : Standard Practice for Preparation of Liquid Blends for Use as Analytical Standards
ASTM    D 4308-13 : Standard Test Method for Electrical Conductivity of Liquid Hydrocarbons by Precision Meter
ASTM    D 4309-12 : Standard Practice for Sample Digestion Using Closed Vessel Microwave Heating Technique for the Determination of Total Metals in Water
ASTM    D 4310-10 : Standard Test Method for Determination of Sludging and Corrosion Tendencies of Inhibited Mineral Oils
ASTM    D 4311/D 4311M-09 : Standard Practice for Determining Asphalt Volume Correction to a Base Temperature
ASTM    D 4312-95a(2010) : Standard Test Method for Toluene-Insoluble (TI) Content of Tar and Pitch (Short Method)
ASTM    D 4313-12 : Standard Specification for  General-Purpose, Heavy-Duty, and Extra-Heavy-Duty Crosslinked Chlorinated Polyethylene (CM) Jackets For Wire and Cable
ASTM    D 4314-12 : Standard Specification for  General-Purpose, Heavy-Duty, and Extra-Heavy-Duty Crosslinked Chlorosulfonated Polyethylene (CSM) Jackets For Wire and Cable
ASTM    D 4315-94(2012) : Standard Test Methods for  Rubber Compounding Material—Zinc Oxide
ASTM    D 4316-95(2010) : Standard Specification for Elastomeric Water Bottles
ASTM    D 4317-98(2011) : Standard Specification for Polyvinyl Acetate-Based Emulsion Adhesives
ASTM    D 4318-10E1 : Standard Test Methods for Liquid Limit, Plastic Limit, and Plasticity Index of Soils
ASTM    D 4320/D 4320M-09 : Standard Practice for Laboratory Preparation of Chemically Grouted Soil Specimens for Obtaining Engineering Parameters
ASTM    D 4321-09 : Standard Test Method for Package Yield of Plastic Film
ASTM    D 4323-84(2009) : Standard Test Method for Hydrogen Sulfide in the Atmosphere by Rate of Change of Reflectance
ASTM    D 4325-13 : Standard Test Methods for Nonmetallic Semi-Conducting and Electrically Insulating Rubber Tapes
ASTM    D 4326-13 : Standard Test Method for Major and Minor Elements in Coal and Coke Ash By X-Ray Fluorescence
ASTM    D 4327-11 : Standard Test Method for Anions in Water by Chemically Suppressed Ion Chromatography
ASTM    D 4328-08(2013) : Standard Practice for Calculation of Supersaturation of Barium Sulfate, Strontium Sulfate, and Calcium Sulfate Dihydrate (Gypsum) in Brackish Water, Seawater, and Brines
ASTM    D 4329-13 : Standard Practice for Fluorescent Ultraviolet (UV) Lamp Apparatus Exposure of Plastics
ASTM    D 4330-94(2008) : Standard Practice for  Evaluation of Fiberglass Boat Polish and Wax
ASTM    D 4332-13 : Standard Practice for Conditioning Containers, Packages, or Packaging Components for Testing
ASTM    D 4333/D 4333M-05(2010)e1 : Test Method for the Compatibility Resistance of Mechanical Pump Dispenser Components
ASTM    D 4334-05(2010) : Standard Test Method for the Determination of the Dip Tube Retention of a Mechanical Pump Dispenser
ASTM    D 4335-99(2010) : Standard Test Method for Determination of Component Retention of a Mechanical Pump Dispenser
ASTM    D 4336-05(2010) : Standard Test Methods for Determination of the Output Per Stroke of a Mechanical Pump Dispenser
ASTM    D 4337-89(2009) : Standard Test Methods for Analysis of Linear Detergent Alkylates
ASTM    D 4338-97(2011)e1 : Standard Test Method for Flexibility Determination of Supported Adhesive Films by Mandrel Bend
ASTM    D 4339-01(2013) : Standard Test Method for Determination of the Odor of Adhesives
ASTM    D 4340-10 : Standard Test Method for Corrosion of Cast Aluminum Alloys in Engine Coolants Under Heat-Rejecting Conditions
ASTM    D 4349-10 : Classification System and Basis for Specification for Polyphenylene Ether (PPE) Materials
ASTM    D 4350-13 : Standard Test Method for Corrosivity Index of Plastics and Fillers
ASTM    D 4354-12 : Standard Practice for Sampling of Geosynthetics and Rolled Erosion Control Products(RECPs) for Testing
ASTM    D 4355-07 : Standard Test Method for Deterioration of Geotextiles by Exposure to Light, Moisture and Heat in a Xenon Arc Type Apparatus
ASTM    D 4359-90(2012) : Standard Test Method for Determining Whether a Material Is a Liquid or a Solid
ASTM    D 4360-11 : Standard Specification for Methyl <span class=”italic”>n</span>-Amyl Ketone
ASTM    D 4361-10 : Standard Test Method for Apparent Tack of Printing Inks and Vehicles by a Three-Roller Tackmeter
ASTM    D 4362-13 : Standard Specification for Propane Thermophysical Property Tables
ASTM    D 4363-12 : Standard Specification for  Thermoplastic Chlorinated Polyethylene (CM) Jacket for Wire and Cable
ASTM    D 4364-13 : Standard Practice for Performing Outdoor Accelerated Weathering Tests of Plastics Using Concentrated Sunlight
ASTM    D 4365-13 : Standard Test Method for Determining Micropore Volume and Zeolite Area of a Catalyst
ASTM    D 4367-02(2012) : Standard Test Method for Benzene in Hydrocarbon Solvents by Gas Chromatography
ASTM    D 4370-01(2012) : Standard Test Methods for Acid and Base Milliequivalent Content of Electrocoat Bath
ASTM    D 4371-06(2012) : Standard Test Method for Determining the Washability Characteristics of Coal
ASTM    D 4373-14 : Standard Test Method for Rapid Determination of Carbonate Content of Soils
ASTM    D 4375-96(2011) : Standard Practice for Basic Statistics in Committee D-19 on Water
ASTM    D 4376-02 (Reapproved 2012) : Standard Specification for Vapor-Degreasing Grade Perchloroethylene
ASTM    D 4377-00(2011) : Standard Test Method for Water in Crude Oils by Potentiometric Karl Fischer Titration
ASTM    D 4378-13 : Standard Practice for In-Service Monitoring of Mineral Turbine Oils for Steam, Gas, and Combined Cycle Turbines
ASTM    D 4380-12 : Standard Test Method for Density of Bentonitic Slurries
ASTM    D 4381/D 4381M-12 : Standard Test Method for Sand Content by Volume of Bentonitic Slurries
ASTM    D 4382-12 : Standard Test Method for Barium in Water, Atomic Absorption Spectrophotometry, Graphite Furnace
ASTM    D 4383-12 : Standard Specification for Plowable, Raised Retroreflective Pavement Markers
ASTM    D 4385-13 : Standard Practice for Classifying Visual Defects in Thermosetting Reinforced Plastic Pultruded Products
ASTM    D 4386-95(2008) : Standard Practice for Application of Floor Polishes to Maintain Multilayer Composite Tile or Flooring
ASTM    D 4388-13 : Standard Specification for Nonmetallic Semi-Conducting and Electrically Insulating Rubber Tapes
ASTM    D 4389/D 4389M-04(2010)e1 : Standard Specification for Finished Glass Fabrics Woven From Rovings
ASTM    D 4391-93A(2013)E1 : Standard Terminology Relating to The Burning Behavior of Textiles
ASTM    D 4394-08 : Standard Test Method for  Determining In Situ Modulus of Deformation of Rock Mass Using Rigid Plate Loading Method
ASTM    D 4395-08 : Standard Test Method for  Determining In Situ Modulus of Deformation of Rock Mass Using Flexible Plate Loading Method
ASTM    D 4396-06 : Standard Specification for Rigid Poly(Vinyl Chloride) (PVC) and Chlorinated Poly(Vinyl Chloride) (CPVC) Compounds for Plastic Pipe and Fittings Used in Nonpressure Applications
ASTM    D 4397-10 : Standard Specification for Polyethylene Sheeting for Construction, Industrial, and Agricultural Applications
ASTM    D 4398-07 : Standard Test Method for Determining the Chemical Resistance of Fiberglass-Reinforced Thermosetting Resins by One-Side Panel Exposure
ASTM    D 4399-05(2011) : Standard Test Method for Measuring Electrical Conductivity of Electrocoat Baths
ASTM    D 4400-99(2012)E1 : Standard Test Method for Sag Resistance of Paints Using a Multinotch Applicator
ASTM    D 4402/D 4402M-13 : Standard Test Method for Viscosity Determination of Asphalt at Elevated Temperatures Using a Rotational Viscometer
ASTM    D 4403-12 : Standard Practice for Extensometers Used in Rock
ASTM    D 4404-10 : Standard Test Method for Determination of Pore Volume and Pore Volume Distribution of Soil and Rock by Mercury Intrusion Porosimetry
ASTM    D 4409-95(2014) : Standard Test Method for Velocity Measurements of Water in Open Channels with Rotating Element Current Meters
ASTM    D 4410-10 : Terminology for Fluvial Sediment
ASTM    D 4411-03(2014)e1 : Standard Guide for Sampling Fluvial Sediment in Motion
ASTM    D 4412-84(2009) : Standard Test Methods for Sulfate-Reducing Bacteria in Water and Water-Formed Deposits
ASTM    D 4413-98(2009)e1 : Standard Test Method for Determination of Ethylene Oxide in Workplace Atmospheres (Charcoal Tube Methodology)
ASTM    D 4414-95(2013) : Standard Practice for Measurement of Wet Film Thickness by Notch Gages
ASTM    D 4416-09 : Standard Specification for Acrylic Acid
ASTM    D 4417-14 : Standard Test Methods for Field Measurement of Surface Profile of Blast Cleaned Steel
ASTM    D 4418-00(2011) : Standard Practice for Receipt, Storage, and Handling of Fuels for<br>  Gas Turbines
ASTM    D 4419-90(2010) : Standard Test Method for Measurement of Transition Temperatures of Petroleum Waxes by Differential Scanning Calorimetry (DSC)
ASTM    D 4422-13 : Standard Test Method for Ash in Analysis of Petroleum Coke
ASTM    D 4423-10 : Standard Test Method for Determination of Carbonyls In C<inf>4</inf> Hydrocarbons
ASTM    D 4424-09 : Standard Test Method for Butylene Analysis by Gas Chromatography
ASTM    D 4425-09 : Standard Test Method for Oil Separation From Lubricating Grease by Centrifuging (Koppers Method)
ASTM    D 4426-01(2006) : Standard Test Method for Determination of Percent Nonvolatile Content of Liquid Phenolic Resins Used for Wood Laminating
ASTM    D 4427-13 : Standard Classification of Peat Samples by Laboratory Testing

QUICK QUOTE

Get Your Quote from Our Materials Scientists within 4 Hours

    Full Name *

    Your Email ID *

    Phone *

    Company

    Testing Needed *

    OR

    EMAIL US

    OR

    CALL US

    USA
    Telephone :+1 770.823.5031
    Telephone:+1 404.918.8782

    INDIA
    Telephone : (0253) 2361782
    Mobile : +91 9552508782

    TESTING SERVICES

     

    [sp_faq category="19"]

      

    [sp_faq category="20"]
    [sp_faq category="21"]
    [sp_faq category="22"]

    Our Team

    Collaborate with us

    Get A Quote

    Our Services

    SEND US A REQUEST

    Need help or have a question? (0253) 2361782

    SEND US A REQUEST